To overcome the failure of cement adhesive bond between tooth and metal surfaces, a variety of alternative treatments is applied to the metal and tooth surfaces. In order to overcome this disadvantage, this study deals with the treatment on the metal surface in mesh form. This research examined different mesh sizes of 40, 60 and 80 mesh to the metal surface treatment in shear bond strength of adhesive resin cement. 40 pairs of upper central incisors samples were prepared in palatal surfaces with a thickness of 0.3 mm and made a pattern of blue wax. The samples were divided into four groups; three mesh treatment groups (40, 60 and 80) and a control group (no mesh). In the treatment groups, a mesh was positioned to the opposing surface of wax pattern to the tooth preparation surface, was casted with nickelchromium alloy, attached to the palatal surface of the teeth with adhesive resin cement, immersed in artificial saliva for 24 hours at 37°C. Moreover, shear bond strength test and residual resin cement on the metal surface were tested in Laboratory of the Department of Metallurgical Engineering. Data was analyzed using one-way ANOVA (p=0.05). Shear bond strength adherence of mesh plates 60 was found greater than 40, 80 and control group. Stereomicroscope inspection of adhesive resin cement remaining on mesh 60 was similar than 40, but more than mesh 80 or control group. It was concluded shear bond strength of adhesive resin cement to metal surfaces depends on the size of mesh used, and shear bond strength of adhesive resin cement that still intact on the mesh surface.